Table of Contents
Advertisement
IP Dest Addr Mask
Subrule Priority
Transport Header
TOS Mask
References:
Generic filter commands
5.13.33 Filter subrule PPP Commands
5.13.33.1 Get Filter subrule ppp
Description:
Use this command to get.
Command Syntax:
get filter subrule ppp [ruleid <ruleid-val>] [subruleid <subruleid-val>]
5.13.33.2 Create filter subrule ppp
Description:
Use this command to create.
Command Syntax:
create filter subrule ppp ruleid <ruleid-val> subruleid <subruleid-val>
[prototypefrom <prototypefrom-val>] [prototypeto <prototypeto-val>]
[prototypecmp eq | neq | lt | leq | gt | geq | any | inrange | exrange] [subruleprio
low | high | asinrule]
5.13.33.3 Delete filter subrule ppp
Description:
Use this command to delete.
436
The mask value for destination ip address. The mask is applied over the
destination ip address before checking against a value.
This specifies the priority of the subrule. Based on this priority value, the
subrule is created in fast or slow memory. In case priority is specified as
asinrule, subrule priority will be same as specified in the rule.
This specifies the type of Transport header in the packet in which IP is
being transported. If value of this field is ethernet (1), then IP is being
carried in ethernet header and if it is pppoe (2) then then IP is being carried
in PPP header.
The mask value for TOS field. The mask is applied over the TOS field value
before checking against configured values in 'tosfrom' and 'tosto'.
IDL series User Guide
Advertisement
Table of Contents
