Table of Contents
Advertisement
enable|disable
Example:
$ create ipoa intf ifname Ipoa-0 lowif aal5-0 configstatus Normal enable
Output:
Verbose Mode On
Entry Created
Ifname
Config Status : Normal
Oper Status
Verbose Mode Off:
Entry Created
Output Fields:
FIELD
Ifname
Low IfName
Config Status
Admin Status
Oper Status
IP DSLAM
Administrative status of the interface.
Type: Optional
Valid values: enable or disable
: Ipoa-0
Low IfName
: Up
Admin Status : Enable
Description
The Ipoa Interface
This specifies the name of the lower AAL5
interface.
This mode describes the configuration status for
this interface. If the "config" bit is set then this
interface shall be created but will have a dormant
status. Only after the receipt of an Ipoa packet
from CPE side this interface shall become active.
The "In-Use" and "Not-In-Use" bits are read only
bits. The "Not-In-Use" indicates that the entry is
dormant and "In-Use" indicates that the entry is
activated.
Administrative status of the interface.
Operational status of the interface.
: aal5-0
477
Advertisement
Table of Contents
