Table of Contents
Advertisement
Command Syntax:
create ipoa intf ifname <interface-name> lowif <lowif-val> [configstatus
Normal | Config] [enable|disable]
5.16.3.3 Delete ipoa intf
Description:
Use this command to delete.
Command Syntax:
delete ipoa intf ifname <interface-name>
5.16.3.4 Modify ipoa intf
Description:
Use this command to modify.
Command Syntax:
modify ipoa intf ifname <interface-name> [enable|disable]
Parameters:
Name
ifname
<interface-name>
lowif <lowif-val>
configstatus Normal
|Config
476
Description
The Ipoa Interface
Type: Create － Mandatory
Delete － Mandatory
Modify － Mandatory
Get － Optional
Valid values: 0 -575
This specifies the name of the lower AAL5 interface.
Type: Create － Mandatory
Valid values: 0 - 574
This mode describes the configuration status for this
interface. If the "config" bit is set then this interface
shall be created but will have a dormant status. Only
after the receipt of an Ipoa packet from CPE side
this interface shall become active. The "In-Use" and
"Not-In-Use" bits are read only bits. The
"Not-In-Use" indicates that the entry is dormant and
"In-Use" indicates that the entry is activated.
Type: Create － Optional
Default value: NormalEntry
IDL series User Guide
Advertisement
Table of Contents
