Table of Contents
Advertisement
Extended PSD Status
Chip Version
Pilot Tone
Overhead Channel
Psd Mask
System Vendor ID
ATU-C Self Test Result
Atuc G.994.1 Vendor ID
Atuc ACTPSDus (dB/10)
AtucStartBin (GSpan++)
StartUp Error Code
BitSwapCount
IP DSLAM
Conexant parameter that indicates whether an extended
upstream PSD is used - for G.Span Plus mode of
operation only. Only supported for G.Span Plus, therefore
this parameter is not valid for ADSL2/ADSL2plus modes of
operation.
The DSP version number.
Conexant parameter that indicates the Pilot Tone Index.
Indicates the Overhead Channel. This feature is not
supported by DSLPHY as yet.
Conexant parameter that indicates the actual Psd Mask
currently being used.
Indicates the Vendor ID as inserted by the ATU-C in the
Overhead Messages(ADSL2). Typically identifies the
ATU-C system integrator which usually refers to the
vendor of the smallest field-replaceable unit. ATU-C
System Vendor ID may not be the same as ATU-C Vendor
ID. It is not available for ADSL. This is string of 8 octets
containing 2 octet country code , 4 octet vendor id and 2
octet vendor revision number.
Defines the ATU-C selftest result. The most significant
octet is: 00 hex if the self-test passed or 01 hex if the
self-test failed. Interpretation of the other octets is vendor
discretionary and can be interpreted in combination with
G.994.1 and system Vendor IDs.
Indicates the Vendor ID as inserted by the ATU-C in the
G.994.1 CL message. Typically identifies the vendor of the
ATU-C G.994.1 functionality. This is string of 8 octets
containing 2 octet country code , 4 octet vendor id and 2
octet vendor revision number.
This parameter defines the average upstream transmit
power spectrum density over the used subcarriers
delivered by the ATU-C at the U-C reference point, at the
instant of measurement. It's value ranges from -90 to 0, in
0.1 dB/Hz steps. It is available only for ADSL2/ADSL2plus.
This Gspan++ parameter indicates the start bin of the bit
loading up array.
Conexant parameter which indicates the startup error
code.
This Conexant parameter indicates the bit swap count. It
can read only in data mode
251
Advertisement
Table of Contents
