Bridge Port Table Commands; Create Bridge Port Intf; Delete Bridge Port Intf - Planet IP DSLAM IDL-2400 User Manual

Output Fields:
Field
PortId
Max Info Size
Out Frames
In Frames
In Discards
HC In Frames
HC Out Frames
HC In Discards

5.6.7 Bridge Port Table Commands

5.6.7.1 Create bridge port intf

Description:
Use this command to create a new bridge port.
Command Syntax:
create bridge port intf portid <portid-val> ifname <interface-name> [maxucast
<max-ucast-addresses> ] [learning enable|disable][status enable|disable]
[stickystatus enable | disable] [FdbModify enable | disable][ aclglbdenyapply
Enable | Disable ] [ aclglbtrackapply Enable | Disable ] [ proxyarpstatus enable |
disable ] [ arptstatus Enable | Disable ] [ darpstatus Enable | Disable ] [ porttype
trusted | untrusted ]

5.6.7.2 Delete bridge port intf

Description:
This command is used to delete an existing bridge port.
Command Syntax:
delete bridge port intf portid <portid-val>
182
Description
This is the bridge port identifier. It can be : 1- 386
The maximum size of the INFO (non-MAC) field that this port will
receive or transmit.
The number of frames that have been transmitted by this port to its
segment.
The number of frames that have been received by this port from its
segment.
Count of valid frames received, which were discarded (i.e., filtered)
by the Forwarding Process.
Number of frames that have been received by this port from its
segment. This is valid only for Ethernet interfaces.
Number of frames that have been transmitted by this port to its
segment. This is valid only for Ethernet interfaces.
Count of valid frames received and discarded (i.e filtered) by the
Forwarding Process. This is valid only for Ethernet interfaces.
IDL series User Guide