Filter Subrule Ip Commands; Get Filter Subrule Ip - Planet IP DSLAM IDL-2400 User Manual

IGMP type comparison
Igmp code
IGMP code comparison
Start group address
End group address
IGMP group address
comparison
Subrule Priority
Transport Header
References:
Generic Filter commands

5.13.32 Filter subrule IP Commands

5.13.32.1 Get Filter subrule ip

Description:
Use this command to get.
Command Syntax:
get filter subrule ip [ruleid <ruleid-val>] [subruleid <subruleid-val >]
IP DSLAM
IGMP type comparison type
This field specifies the Max Response Code (time) fields of
IGMP packet. This field is invalid if igmphCodeCmpType is
any.
IGMP code comparison type
Start group address of the range of igmp group addresses.This
field is invalid if 'igmpgroupaddrcmp' is 'any'. This field and
'groupaddrto' specify a range of IGMP group addresses, if
'igmpgroupaddrcmp' is either 'inrange' or 'exrange'
End group address of the range of igmp group addresses. This
field and 'groupaddrfrom' specifiy a range of IGMP group
addresses, if 'igmpgroupaddrcmp' is either 'inrange' or 'exrange'
IGMP group address comparison type
This specifies the priority of the subrule. Based on this priority
value, the subrule is created in fast or slow memory. In case
priority is specified as 'asinrule', subrule priority will be same as
specified in the rule.
This specifies the type of the transport header in the packet in
which the corresponding IP is being transported. If the value of
this field is Ethernet(0x1), then the IP is being carried in the
ethernet header. If it is pppoe(0x2), then the corresponding IP is
being carried in the PPP header.
429