Get Traps - Planet IP DSLAM IDL-2400 User Manual

Parameters:
Name
Num-of-traps
Mode:
Super-User, User
Example:

$ get traps

Output
Thu Jan 01 00:00:13 1970 : STATUS ALARM : ATM VC Up :Interface Name–
aal5-0
Thu Jan 01 00:00:13 1970 : STATUS ALARM : System Up
Output Fields
FIELD
Trap time
Trap severity
Trap name
630
Description
This specifies the maximum number of (entries)
traps to be displayed from trap log table; if not
specified then all entries are displayed.
Type: Optional
Valid values : 0 to 4294967295
Description
This specifies the time at which the trap was logged.
This specifies the severity level of the trap. It can be –
CRITICAL ALARM
MAJOR ALARM
WARNING
STATUS ALARM
This specifies the name of the trap. It can be –
System Init Failed - This trap is originated at the time of system initialization
failures. The failure could be due to an internal error or due to a
wrong/corrupted configuration file. Trap parameters are Module and Cause.
System Up - This trap is originated after the unit boots up successfully.
ADSL ATUC Up - This trap indicates that the DSL port is in data mode.
ADSL ATUC Down - This trap indicates that the DSL port is no longer in data
mode.
ATM Interface Up - This trap indicates that the ATM port is operationally up.
Trap parameter is Interface No.
ATM Interface Down - This trap indicates that the ATM port is operationally
down. Trap parameter is Interface No.
ETHER Interface Up - This trap indicates that the Ethernet port is
IDL series User Guide