Table of Contents
Advertisement
3.8 DSL
This section describes how to configure DSL settings by selecting DSL from Function List
Window.
3.8.1 Profile
Allow users to configure Line Profile and Alarm Profile.
3.8.1.1 Line Profile
If to configure Line Profile, double click on "Line Profile" from the Function List
Window. The Line Profile configuration window appears.
Field
Line Type
Transmit Rate Mode
Target SNR (dB/10)
Min Tx Rate(bps)
Down Shift SNR (dB/10)
IntCorrectionUP
Preferred Standard
Maximum Transmit Rate
Interleave Delay (ms)
UP Shift SNR (dB/10)
IntCorrectionDown
Annex Type
IP DSLAM
Definition
The ADSL line type, Fast or Interleaved.
Defines what form of transmitting rate, Fixed or adaptAtStartup.
Target Signal / Noise Margin. (0-310).
The minimum transmitting rate of ATU-C side or ATU-R side.
Configured Signal/ Noise Margin for rate downshift. If the noise margin
falls below this level, the modem should attempt to decrease its transmit
rate. In the case that RADSL mode is not present, the value will be 0.
Sets the correction time for the upstream interleaved buffer. RS can also
be disabled.
Preferred standard compliance. Outcome is dependent
upon standard support of the remote unit. GlobespanVirata High Speed
ADSL DMT (ADSL+) applications only.
The maximum transmitting rate of ATU-C side or ATU-R side.
The value of Interleave Delay for this channel.
Configured Signal/ Noise Margin for rate upshift. If the noise margin rises
above this level, the modem should attempt to increase its transmit rate.
In the case that RADSL is not present, the value will be 0.
This parameter sets the correction time for the downstream interleaved
buffer. RS can also be disabled.
This parameter is set as per Annex compliance of the code release.
GlobespanVirata High Speed ADSL DMT (ADSL+) applications only.
65
Advertisement
Table of Contents
