Table of Contents
Advertisement
enable|disable
Example:
$ create ipoe intf ifname Ipoe-0 lowif Ipoa-0 macaddrprof 1 ethpkttype Type2
inactivitytmrintrvl 10 routingstatus disable cfgmode Auto enable
Output:
Verbose Mode On
Entry Created
Ifname
Mac Addr Prof
InActivity Tmr Interval : 10
RoutingStatus
Oper Status
Verbose Mode Off:
Entry Created
Output Fields:
FIELD
Ifname
Low If Name
Mac Addr Prof
Eth Pkt Type
InActivity Tmr Interval
480
Type: Create － Optional
Modify － Optional
Default value:enable
Administrative Status of the interface.
Type: Optional
Valid values: enable or disable
: Ipoe-0
Low If Name : Ipoa-0
: 1
Eth Pkt Type : Type2
: disable
: Up
Admin Status : Enable
Description
The IPOE Tunneling Interface.
This specifies the lower interface index.It contains the
ifindex of the IPoA interface.
Profile Id corresponding to the MAC address assigned to
this IPOE interface. This Profile is created using the
MacAddrProfileTable.
This specifies the type of the Packet.
This field specifies the time (in seconds) after which
interfaces shall be marked inactive, if there is no data
activity on this interface during this interval. This is used
only when the bit corresponding to "ConfigEntry" is set for
gsvIpoeConfigStatus field. A value of zero means the timer
is not running. In autosensing scenario, an inactive
interface is a candidate to deletion, if another protocol is
sensed on Atm Vc Interface on which this interface is
created
IDL series User Guide
Advertisement
Table of Contents
