Planet IP DSLAM IDL-2400 User Manual page 162

Verbose Mode Off:
Entry Created
Output Fields:
Field
IfName
LowIfName
MaxVccs
MaxConfVccs
MaxVpiBits
MaxVciBits
OAMSrc
ORL(kbps)
UnknownVPI
UnknownVCI
ProfileName
Current Output Rate
trfclassprofileid
Ctl Pkts Instance Id
ATM Transport Type
162
Description
Physical interface index
This is the IfIndex of the low interface on which this ATM port is configured.
Lower interface can be of type 94 or 124 or 125 or 0xfffffff9
This specifies the maximum number of VCCs (PVCCs), supported at this
ATM interface. This field is not valid if the atmtransporttype has the value
packet
This specifies the current number of VCCs configured on this port.
The maximum number of active VPI bits configured for use at the ATM
interface.
This specifies the maximum number of active VCI bits configured for use at
this ATM interface.
Loopback source id assigned to the ATM port. The ATM port will respond to
all loopback cells, which carry this OAM id. This field is not valid if the
atmtransporttype has the value packet.
This parameter specifies the output rate limiting value in KBPS to be applied
on this interface.
This parameter specifies the last seen unknown VPI on this ATM interface.
This field is not valid if the atmtransporttype has the value packet.
This parameter specifies the last seen unknown VCI on this ATM interface.
This field is not valid if the atmtransporttype has the value packet.
This specifies the scheduling profile to be associated with the ATM port.
This parameter specifies the current output rate value in KBPS that is
available on this interface, based on the minimum of DSL trained rate and
OutPut Rate limit configured for the ATM port.
This specifies the traffic class profile to be associated with the ATM port.
This specifies the control packet instance identifier associated with this
interface. If the user does not provide any instance identifier while creating an
interface an instance is created internally from the default profile governed by
the macro 1 and associated to the interface. This will reduce the total number
to instances that can be now created by one. The default instance is
governed by macro 0.
This specifies the transport type of the atm interface. This can be either Cell
which means that actual Atm Cells shall be received over the UTOPIA
interface, or Packet , which means that Pseudo Cells corresponding to
Packet VDSL shall be received over this ATM interface. This is not modifiable
IDL series User Guide