Planet IP DSLAM IDL-2400 User Manual page 289

Ip dslam
Table of Contents

Advertisement

atucconfpml2minrate
<atucconfpml2minrate-val>
atucconfmsgminds
<atucconfmsgminds-val>
aturconfmsgminus
<aturconfmsgminus-val>
atucminsnrmgn
<atucminsnrmgn-val>
aturminsnrmgn
<aturminsnrmgn-val>
atucfrontenddesigntype
El1508 | El1528 | Le87213
atuchwpwrreduction Disable
| Enable
atucgsusbitswap Disable |
Enable
aturmaxsnrmgn
<aturmaxsnrmgn-val>
IP DSLAM
Type: Modify -- Optional
Valid values: 0 - 310
PM configuration parameter, related to the L2 low power state. This
parameter specifies the minimum net data rate during the low power
state (L2). The data rate is coded in bit/s, and can range from 0x1F40
(8000) bps to 0xFA000 (1024000) bps.
Type: Modify -- Optional
Valid values: 0x1F40 - 0xFA000
Configures downstream overhead channel bandwidth. This feature is
not supported by DSLPHY as yet.
Type: Modify -- Optional
Valid values: 4000 - 64000
Configures upstream overhead channel bandwidth.This feature is not
supported by DSLPHY as yet.
Type: Modify -- Optional
Valid values: 4000 - 64000
Atuc Configured Minimum Signal/Noise Margin. This is the Noise
Margin, the modem must achieve with a BER of 10 to the power -7 or
better, to successfully complete initialization. The default value
mentioned is an indicative value only.
Type: Modify -- Optional
Valid values: 0 - 310
Atuc Configured Minimum Signal/Noise Margin. This is the Noise
Margin, the modem must achieve with a BER of 10 to the power -7 or
better, to successfully complete initialization. The default value
mentioned is an indicative value only.
Type: Modify -- Optional
Valid values: 0 - 310
Front end hardware reference design
Type: Modify -- Optional
Hardware configuration parameter
Type: Modify -- Optional
This parameter enables/disables upstream bit swapping
Type: Modify -- Optional
Configured Maximum acceptable downstream Signal/Noise Margin. If
the Noise Margin is above this the modem attempts to reduce its power
output to optimize its operation. The value set by the user is in dB/10,
and ranges from 0 to 31 dB in 1 dB steps.
Type: Modify -- Optional
Valid values: 0 - 310
289

Advertisement

Table of Contents
loading

This manual is also suitable for:

Idl-2401Idl-4800Idl-4801

Table of Contents