Table of Contents
Advertisement
Ifname
Route Type
Route Orig
Age
ProxyArpStatus
References:
get ip route command
delete ip route command
arp related commands.
5.16.3 Ipoa intf Commands
5.16.3.1 Get ipoa intf
Description:
Use this command to get.
Command Syntax:
get ipoa intf [ifname <interface-name>]
5.16.3.2 Create ipoa intf
Description:
Use this command to create.
IP DSLAM
can be added in the downstream direction for the IPOE interfaces
(gsvIpRouteIfIndex as ipoe-*). The next hop in such cases has to be
same as the destination IP address (gsvIpRouteDest) specified.
The index value which uniquely identifies the local interface through
which the next hop of this route should be reached. If IpRouteRid is
not GS_CFG_MGMT_RID, than u32IpRouteIfIndex shall be
mandatory to be specified in the "create ip route" command. The
ifname value can be either ANYWAN or ifindex of any of the ipoe
interface (ipoe-*).
The type of route. It may be: dir (for Direct) or ind (for Indirect).
The routing mechanism, through which this route was learned. It
may be: NET (for Network Management), LCL (for Local), RIP,
ICMP,DYI (Dynamic through Interface creation).
The number of seconds since this route was last updated or
otherwise determined to be correct.
This specifies if the Proxy ARP has to be done for this iproute
table entry.If IpRouteRid value is 0, then ProxyArpStatus will not be
specified while creating/modifying an entry in IpRoute Table.
475
Advertisement
Table of Contents
