Table of Contents
Advertisement
seqid <seqid-val>
ifname
<interface-name>
stageid <stageid-val>
seqdir in | out
Example:
$ create filter seq info seqid 1 ifname eoa-0 stageid 1 seqdir 1
Output:
Verbose Mode On
Entry Created
Sequence Id : 1
Verbose Mode Off:
Entry Created
396
Sequence Id of the sequence
Type: Create -- Mandatory
Delete -- Mandatory
Modify -- Mandatory
Get --Optional
Valid Values: 1-65535
The name of the interface whose mapping is being created. Only EoA, PPPoE,
and Ethernet interfaces are allowed. If the value of this field is 'alleth', it
indicates all 'Ethernet' interfaces. If the bridge port is created over the
aggregated interface, then this field cannot have IfIndex of any specific
Ethernet interface. If the bridge port over the aggregated interface is not
created, then this field cannot have the value 'alleth'. This field should not be
specified during creation of an entry in this table and must be specified during
modify of an entry in this table.
Type: Create -- Optional
Modify -- Optional
Identifier of the stage on the interface for which the sequence is being
applied.This field should not be specified during creation of an entry in this
table and must be specified during modify of an entry in this table
Type: Create -- Optional
Modify -- Optional
Valid values: 1-2
Default Value:1
This field specifies whether the sequence to be applied in ingress direction or
egress direction on the interface.This field should not be specified during
creation of an entry in this table and must be specified during modify of an entry
in this table.
Type: Create -- Optional
Modify -- Optional
Default value: In
IDL series User Guide
Advertisement
Table of Contents
