Table of Contents
Advertisement
aturintlmaxtxrate
<aturintlmaxtxrate-val>
aturmaxintldelay
<aturmaxintldelay-val>
databoost Enable | Disable
upstreampsd Extended |
Standard | Jj100
atucconfpmmode
pmstatel3enable |
pmstatel2enable | disable
atucconfpml0time
<atucconfpml0time-val>
atucconfpml2time
<atucconfpml2time-val>
atucconfpml2atpr
<atucconfpml2atpr-val>
288
Configured Maximum Transmit rate for 'Interleave' channels, in bps.
Also refer to 'adslAturConfRateChanRatio' for information regarding
RADSL mode and to ATU-C transmit rate for ATU-R receive rates.
Type: Modify -- Optional
Valid values: 0 - 0xffffffff
Configured maximum Interleave Delay for this channel. Interleave
delay applies only to the interleave channel and defines the mapping
(relative spacing) between subsequent input bytes at the interleaver
input and their placement in the bit stream at the interleaver output.
Larger numbers provide greater separation between consecutive input
bytes in the output bit stream, allowing for improved impulse noise
immunity at the expense of payload latency
Type: Modify -- Optional
Valid values: 0 - 0xffffffff
Conexant parameter that enables/disables DataBoost option.
Type: Modify -- Optional
Conexant parameter that sets the upstream PSD to be either
extended or standard. Used for GSpan Plus only.
Type: Modify -- Optional
PM-related parameter used by the ATU-C to set the allowed link states.
Both bit values can be given simultaneously in the input. Additional
value to disable pmmode is disable, which is equal to 0.
Type: Modify -- Optional
PM configuration parameter, related to the L2 low power state. This
parameter represents the minimum time (in seconds) between an exit
from the L2 state and the next entry into the L2 state. It ranges from 0 to
255 seconds.
Type: Modify -- Optional
Valid values: 0 - 255
PM configuration parameter, related to the L2 low power state. This
parameter represents the minimum time (in seconds) between an Entry
into the L2 state and the first Power Trim in the L2 state and between
two consecutive Power Trims in the L2 State. It ranges from 0 to 255
seconds.
Type: Modify -- Optional
Valid values: 0 - 255
PM configuration parameter, related to the L2 low power state. This
parameter represents the maximum aggregate transmit power
reduction (in dB) that can be performed through a single Power Trim in
the L2 state. It ranges from 0 dB/10 to 310 dB/10.
IDL series User Guide
Advertisement
Table of Contents
