Ethernet - Planet IP DSLAM IDL-2400 User Manual

a. Select the VLAN to view or modify by using the VLAN ID drop-down list.
b. Use Egress PVC and Untagged PVC drop-down list to set the specified DSL port's
Egress PVC and Untagged PVC.
c. Click on
Configuration window.

3.7.2 Ethernet

Allow user to view and modify Ethernet configuration. Double Click on "Ethernet" from the
Function List Window. The Ethernet Configuration window appears as follows.
Field
DHCP
Type
Admin Status
Operation Status
IP address
Mask
Gateway
Mgmt Vlan Index
IP DSLAM
to submit your settings or click on
Definition
DHCP client enabled or disabled
Uplink or Downlink
The desired state of UPLINK (enable/disable)
System is enabled or not.
IP address of the UPLINK
The network mask of the UPLINK.
Gateway IP
VLAN for management traffic on this interface. Nonzero value
of this field is valid only if either 'ip' field is non-zero or 'usedhcp'
field is true. If no Management Vlanid is specified (in the create
operation) or its value is set to zero (either in create or modify
operation) then the system shall use the value of 'portvlanid'
associated with the bridge port created on this interface as the
Management Vlan Index. In case the management vlan (i.e.
'mgmtvlanid' or the associated 'portvlanid', if 'mgmtvlanid' is
zero) doesn't exist on the system then management shall not
happen on this interface till the corresponding VLAN is created
with the Net side port as its member.
to close the VLAN
63