Table of Contents
Advertisement
Example:
$ modify stp info priority 0x20 maxage 25 htime 5 fdelay 20 enable
Output:
Protocol Spec. : IEEE 8021D
Top. Changes
Desig Root
Root Port
Br Max Age(sec) : 25
Br Hello Time(sec) : 5
Br Fwd Delay(sec) : 20
STP status
Verbose Mode Off
Set Done
Output Fields:
Field
Protocol Spec
Priority
Top. Changes
Curr Top. Age(Sec)
Desig Root
Root Cost
Root Port
Hold Time (Sec)
200
mode.
Type : Optional
Valid values:
Priority : 0x20
: 1
: 00:30:4F:10:5A:6C:DB:20 Root Cost : 0
: None
Curr Max Age (sec) : 20.0
Curr Hello Time(sec) :2.0
Curr Fwd Delay (sec) :15.0
: enable
Description
An indication of what version of the Spanning Tree Protocol is
being run.
The value of the write-able portion of the Bridge ID,i.e.,the first
two octets of the (8 octet long) Bridge ID. The other (last) 6
octets of the Bridge ID are given by the value of
dot1dBaseBridgeAddress.
The total number of topology changes detected by this bridge
since the management entity was last reset or initialized.
The time (in second) since the last time a topology change was
detected by the bridge entity.
The bridge identifier of the root of the spanning tree as
determined by the Spanning Tree Protocol as executed by this
node. This value is used as the Root Identifier parameter in all
Configuration Bridge PDUs originated by this node.
The cost of the path to the root as seen from this bridge.
The port number of the port which offers the lowest cost path from
this bridge to the root bridge.
This time value determines the interval length during which no
more than two Configuration bridge PDUs shall be transmitted by
disable | enable
Curr Top. Age(sec) : 35.0
Hold Time (sec) : 1.0
IDL series User Guide
Advertisement
Table of Contents
