Planet IP DSLAM IDL-2400 User Manual page 296

Max Nom AtpPsd(dB/10)
Min INP
Upstream PSD Mask :
------------------------
[ 0] 0
Output Fields:
FIELD
IfName
Rate Adaptation
Target Snr Margin(dB/10)
Max Snr Mgn(dB/10)
GsRsIntCorrectionUp
Dnshift SnrMargin(dB/10)
Upshift SnrMargin(dB/10)
Min Upshift Time(sec)
Min Dnshift Time(sec)
Fast Min Tx Rate(bps)
Intl Min Tx Rate(bps)
296
: 125 Rate Adaptation
: Inp0
Description
The ADSL line interface name, whose profile is to be modified or
viewed
Defines what form of transmit rate adaptation is configured on
this modem. Refer to ADSL Forum TR-005 for more information.
Configured Target Signal/Noise Margin. This is the Noise Margin
the modem must achieve with a BER of 10 to the power -7, or
better, to successfully complete initialization.
Configured Maximum acceptable Signal/Noise Margin. If the
Noise Margin is above this, the modem hould attempt to reduce its
power output to optimize its operation.
Sets the correction time for the upstream interleaved buffer. RS
can also be disabled.
Configured Signal/Noise Margin for rate downshift. If the noise
margin falls below this level, the modem should attempt to
decrease its transmit rate. In the case that RADSL mode is not
present, the value will be 0.
Configured Signal/Noise Margin for rate upshift. If the noise
margin rises above this level, the modem should attempt to
increase its transmit rate. In thecase that RADSL is not present,
the value will be 0.
Minimum time that the current margin is above UpshiftSnrMgn
before an upshift occurs. In the case that RADSL is not present,
the value will be 0.
Minimum time that the current margin is above UpshiftSnrMgn
before an upshift occurs. In the case that RADSL is not present,
the value will be 0.
Configured Minimum Transmit rate for 'Fast' channels, in bps.
Also refer to 'adslAtucConfRateChanRatio' for information
regarding RADSL mode and refer to ATU-R transmit rate for
ATU-C receive rates.
Configured Minimum Transmit rate for 'Interleave' channels, in
: fixed
IDL series User Guide