Planet IP DSLAM IDL-2400 User Manual page 363

mask mask
value value
act
Drop|Fwd|FwdToCtl|
CpToCtl|Eq|Gt|Lt|InR
ange|TerCmp|
SetPrio|MatchInList|A
ccDeny|SetBase|Cou
nt| Retagprio |
MatchIngenlist|
GoToNextRule|allow
IP DSLAM
ValueType is U8 the offset can be odd or even. If the ValueType is
U16, U32 or U64 then the offset can only be even. This field is not
valid for any other value type.
Type: Modify -- Optional
Valid values: 0 - 65
Default value: -----
Mask, used to select the individual bits to be matched in a
packet. If gsvClfrTreeNodeAction is SetBase and
gsvClfrTreeNodeSetBaseType is Compute, then this value is used
to specify the mask, which shall be used to identify the individual bits
of the field of the packet used to compute the new base offset. This
field is valid only if the gsvClfrTreeNodeValType is U8, U16, U32
or U64. This field is also valid if the gsvClfrTreeNodeAction is
MatchInGenList.
Type: Modify -- Optional
Default value: -----
Value, to be matched. For NonLinear node types, this field is not
valid. For Linear node types, this
value is used to specify the start of the range. If
gsvClfrTreeNodeAction is SetBase and NodeSetBaseType is
Compute then this field is used to specify the value, which is to be
added to base offset to calculate new base offset. If the
gsvClfrTreeNodeAction is SetPrio or RetagPrio then this field is
used to specify the priority which is to be assigned to the packet. If
the gsvClfrTreeNodeAction is MatchInGenList then this
field is not valid. If the gsvClfrTreeNodeAction is Count, then this
field is read only and specifies total
number of octets of the packets hitting this node.
Type: Modify -- Optional
Default value: -----
Action tells what is to be done by a node. 'Drop' means drop the
packet. 'Fwd' means Forward the packet. 'FwdToCtl' means
Forward the packet to control plane. 'CpToCtl' means forward the
packet and also send a copy of the packet to control plane.'Allow'
means give the packet to the next stage. 'GoToNextRule' means go
to the next rule (ruleid) attached on that interface and if no next rule
is attached on that interface then forward the packet. 'Eq' means
check if value specified in the packet is equal to 'Value'. 'Gt' means
check if the value at the location specified in the packet is greater
than 'Value'. 'Lt' means check if the value at the location specified in
the packet is Less than 'Value'. 'InRange' means check if the value
363