Table of Contents
Advertisement
5.12 EOA Commands
5.12.1 EOA Commands
5.12.1.1 Create eoa intf
Description:
Use this command to create an EoA interface towards the CPE side.
Command Syntax:
create eoa intf ifname <interface-name> lowif <low-interface-name> [pkttype
{multicast |broadcast |unknown-unicast} + | all|None] [fcs false | true]
[enable|disable] [inactivitytmrintrvl <inactivitytmrintrvl-val>] [m2vmacdbid
<m2vmacdbid-val> |none] [configstatus normal | config]
5.12.1.2 Delete oea intf
Description:
Use this command to delete an EoA interface.
Command Syntax:
delete eoa intf ifname <interface-name>
5.12.1.3 Get eoa intf
Description:
Use this command to get information on a particular EoA interface, or on all the
EoA interfaces.
Command Syntax:
get eoa intf [ifname <interface-name>]
5.12.1.4 Modify eoa intf
Description:
Use this command to modify the properties of an eoa interface.
Command Syntax:
modify eoa intf ifname <interface-name> [pkttype {multicast |broadcast
|unknown- unicast} + | all| none] [fcs false | true] [m2vmacdbid
<m2vmacdbid-val> | none] [enable|disable] [inactivitytmrintrvl
<inactivitytmrintrvl>]
328
IDL series User Guide
Advertisement
Table of Contents
