Planet IP DSLAM IDL-2400 User Manual page 450

Output:
Query Interval
StartUp Query Interval
Anxious Timer
Last Member Query Interval : 125
Igmp Snoop Status
Version Mask
Report Suppression Status : Enable
StartUp QryCount
Output field:
Field
Query Interval
Query Response
Interval
StartUp Query Interval
UnSolicRprtInterval
Anxious Timer
V1 Host Timer
Last Member Query
Interval
450
: 12 Query Response Interval : 10
: 10 UnSolicRprtInterval
: 125
Robustness Variable
: Enable
: v3
Proxy Report Status
: 2
Description
This parameter is used to calculate the entry age out timer, when
no reports or queries are received on the entry. When the value
of this parameter multiplied by 10, it should be greater than the
Query Interval configured at the router. The time for which an
entry created at Igmpsnoop module exists, if no messages are
received for it is approximately
(((QueryInterval*10)*Robustness) + Query Response Time
received in Last Query)
This parameter is used to derive Max Response Code to be filled
in General query that will be initiated from Columbia
This parameter specifies the interval between General Queries
sent on receiving Port Up topology change trigger.
This parameter specifies the interval between unsolicited
membership reports of a group sent for robustness no of
times.This field is applicable only when proxy reporting is
enabled.
This parameter specifies the maximum time (in seconds) before
which the IgmpSnoop module will forward all IGMP membership
reports received. It is started once, whenever the first
membership report is received for a group, to ensure that reports
are forwarded for a sufficiently long time, to take care of any lost
reports. The unit is seconds.
This parameter specifies the maximum time (in seconds), for
which the IgmpSnooping module can assume that there are
Version 1 group members present, for the group for which this
timer is running. The unit of this parameter is seconds.
This parameter specifies the Last Member Query Interval that is
the Max Response Time inserted into Group-Specific Queries
V1 Host Timer
Last Member QryCount
: 10
: 130
: 2
: Enable
: 100
IDL series User Guide