Table of Contents
Advertisement
diffdelaytolupstrm
<diffdelaytolupstrm-val>
diffdelaytoldnstrm
<diffdelaytoldnstrm-val>
asmprotocol Enable
|Disable
sidformat EightBitSid
|TwelveBitSid
maxrxbitrateratio
<maxrxbitrateratio-val>
linkhecthrshld
<linkhecthrshld-val>
numoflinksupforgrpup
One | All
IP DSLAM
The maximum differential delay among member links in a bonding group in
Upstream direction. Type: Create － Optional
Modify － Optional
Valid values: 0 -4
Default value: 4
The maximum differential delay among member links in a bonding group in
downstream direction. Type: Create － Optional
Modify － Optional
Valid values: 0 -24
Default value: 4
This parameter specifies whether Autonomous Status Messages will be
exchanged between CO and CPE. If it is disabled then the group would be
bonded statically and CO would assume CPE to know all the configuration
parameters like SID format, number of links in the bonded group and the
links participating in bonding. If it is enabled then CO would inform all these
parameters to CPE using Autonomous Status Messages.
Type: Create － Optional
Modify － Optional
Default value: enable
SID Format: 8 bit or 12 bit SID. Only 8 bit format is being supported
Type: Create － Optional
Modify － Optional
Default value: 1
The maximum bit rate ratio among member links in a bonding group in
upstream direction.
Type: Create － Optional
Modify － Optional
Valid values: 1 -4
Default value: 4
HEC Error percentage of the link upstream rate which will act as Threshold
for link to be part of group in Rx direction
Type: Create － Optional
Modify － Optional
Valid values: 1 -10
Default value: 2
This field specifies the number of links required to be up for bonding to start
ASM protocol
Type: Create － Optional
Modify － Optional
Default value: 0
123
Advertisement
Table of Contents
