Adsl Atur Interval Commands; Get Adsl Atur Interval - Planet IP DSLAM IDL-2400 User Manual

5.9.14 ADSL ATUR Interval Commands

5.9.14.1 Get adsl atur interval

Description:
This command is used to get.
Command Syntax:
get adsl atur interval ifname <interface-name> [nintrvl <nintrvl-val>]
Parameters:
Name
ifname
<interface-name>
nintrvl <nintrvl-val>
Example:
$ get adsl atur interval ifname dsl-0 nintrvl 1
Output:
Ifname
IntervalNumber
IntervalLofs(sec) : 10
IntervalLprs(sec) : 10
IntervalLESs(sec) : 10
Output Fields:
FIELD Description
Ifname The IfIndex of DSL port
IntervalNumber Count from 1 through 96 of 15 minute intervals. Performance Data Interval number 1 is the
most recent previous interval; interval 96 is 24 hours ago.
IntervalValidData This variable indicates if the data for this interval is valid.
IntervalLofs(sec) Count of seconds in the interval when there was Loss of Framing.
IntervalLoss(sec) Count of seconds in the interval when there was Loss of Signal.
IntervalLprs(sec) Count of seconds in the interval when there was Loss of Power.
IntervalESs(sec) Count of Errored Seconds in the interval. The errored second parameter is a count of
one-second intervals containing one or more crc anomalies, or one or more los or sef defects.
IP DSLAM
Description
The ADSL interface name.
Type : Get – Mandatory
Valid values: dsl-0 – dsl-23
Number of 15 minutes intervals.
Type: Get － Optional
Valid values: 1 - 96
: dsl-0
: 1 IntervalValidData : true
IntervalLoss(sec) : 10
263