Table of Contents
Advertisement
VC Type
Max simultaneous protocol
Auto Status
Auto Supported Protocol
Auto VC Mux Forced Protocol : None
Auto Sense Trigger Type
Auto Curr Sensed Encaps Typee : none
Ctl Pkts Group Id
Auto Supported Protocol : pppoa eoa
Output Fields:
Field
VC IfName
Low IfName
VPI
VCI
Oper Status
Admin Status
Aal5 Tx Size
Aal5 Rx Size
Aal Type
Aal5 Encap
channel
168
: PVC
VC Topology
: 1
: Disable
: pppoa eoa
: dynamic
: none
Description
VC Interface Name. It can be : aal5-0 - *
Interface Index of the ATM port, on which this VC is getting configured.
Virtual Path Identifier. In order to modify, the VPI value shall be the new
VPI value and the admin status of VC interface shall be disabled. Also, the
VPI and VCI value cannot be modified along with admin status in one
command. If encaptype is Ethernet than value of this field has to be 0.
Virtual Circuit Identifier. In order to modify, the VCI value shall be the new
VCI value and the admin status of VC interface shall be disabled. Also, the
VPI and VCI value cannot be modified along with admin status in one
command. If encaptype is Ethernet than value of this field has to be 0.
This specifies the actual/current state of the interface. It can be either Up
or Down
This specifies the desired state of the interface. It may be either Up/Down.
This specifies the transmit CPCS SDU size to be used.
This specifies the receive CPCS SDU size to be used.
This specifies the AAL type in use for this VC. The only type of AAL
supported in Columbia Packet is AAL5. This field is not valid for an ATM
VC with encaptype as Ethernet.
This specifies the data encapsulation method to be used over the AAL5
SSCS layer. "auto" means autosense the muxType(llc/vc). Auto mode is
only used to sense the llc/vcmux . Atm VC with encaptype as ethernet can
be created only over an ATM port which has value of atmtransporttype as
packet.The VPI/VCI values for this atm vc shall be 0/0. aaltype,
mgmtmode and oam related parameters are not valid for an ATM VC with
encaptype as Ethernet.
This extension specifies the type of channel on which the ATM VC's cells
have to be transmitted/received. This field is deprecated and currently
not in use.
: Point to Point
IDL series User Guide
Advertisement
Table of Contents
