Table of Contents
Advertisement
Maximum Snr Margin(dB/10)
PSD MoD Enable
PsdMod FallBackEnable
Max Nom PSD(dB/10)
Max Nom AtpPsd(dB/10)
Rate Adaptation
Min INP
US PSD Mask
References:
ADSL Commands
302
or better, to successfully complete initialization. The default value
mentioned is an indicative value only.
Configured Maximum acceptable downstream Signal/Noise
Margin. If the Noise Margin is above this the modem attempts to
reduce its power output to optimize its operation. The value set by
the user is in dB/10, and ranges from 0 to 31 dB in 1 dB steps.
Conexant parameter used to enable the Mask on Demand(MoD)
feature in the upstream direction. It is available only for ADSL2
Annex A ONLY.(length = 4 bytes)
Conexant parameter used to enable Mask on Demand (MoD)
fallback mode. When enabled, the system chooses MoD or the
base ADSL2 depending upon the upstream rate. It is avaiable only
for ADSL2 Annex A.(length = 4 bytes)
This parameter specifies the maximum nominal transmit
PSD(MAXNOMPSD) level during initialization and showtime.
Value depends on CO MIB element settings and near end
transmitter capabilities and is exchanged in the G.994.1 Phase. It
is available only for ADSL2/ADSL2plus. Value ranges from -60 to
-38 in steps of 0.1 dBm/Hz.(length = 4 bytes)
This parameter specifies the maximum nominal aggregate
transmit power(MAXNOMATP) level during initialization and
showtime. Value depends on CO MIB element settings and local
capabilities and is exchanged in the G.994.1 Phase. It is available
only for ADSL2/ADSL2plus. Value ranges from 0 to 25.5 in steps
of 0.1 dBm.(length = 4 bytes)
Defines what form of transmit rate adaptation is configured on this
modem. The default value mentioned is an indicative value only.
Parameter used to specify the minimum impulse noise protection
for the upstream bearer channel. Supported for
ADSL2/ADSL2plus ONLY
This configuration parameter defines that the upstream PSD mask
applicable at the U C2 reference point. This MIB PSD mask may
impose PSD restrictions in addition to the Limit PSD mask defined
in the relevant Recommendation (e.g., G.992.5). It is available
only for Annexes J and M of ADSL2/ADSL2plus.(length = 4 bytes)
IDL series User Guide
Advertisement
Table of Contents
