Table of Contents
Advertisement
Pvc
channel
fast|interleaved
Maxnumproto
<maxnumproto-val>
Autostatus
Enable|Disable
autosupportedprot
none|{pppoa | eoa |
ipoa}+
autovcmuxforcedprot
None | pppoa | eoa |
ipoa
166
is only used to sense the llc/vcmux. Atm VC with encaptype as ethernet
can be created only over an ATM port which has value of
atmtransporttype as packet.The VPI/VCI values for this atm vc shall be
0/0. aaltype, mgmtmode and oam related parameters are not valid for
an ATM VC with encaptype as Ethernet.
Type: Optional
Default Value: llcmux
This specifies the type of VC. The only value supported is PVC.
Type: Optional
Default Value: pvc
This extension specifies the type of channel on which the ATM VC's
cells have to be transmitted/ received. This field is deprecated and
currently not in use.
Type: Optional
Default Value: Interleaved
This field specifies the maximum number of simultaneous active
protocol stacks supported on this interface. Currently, only one protocol
stack is supported.
Type: Create － Optional
Default value: 1
This field specifies whether the Auto mode is to be enabled or not. In
the Auto mode, the stack above this interface will be determined and
created based on the protocol packets sensed on this interface. For
example, if the protocol packet sensed above this interface is an EoA
packet, then the corresponding EoA stack will be created above this
interface. However, the corresponding EoA interface must have been
created with the config status field set as config mode. This field is not
valid if encaptype is Ethernet.
Type: Create － Optional
Default value: disable
This field specifies Higher layer protocols which are supported for auto
detection on the given ATM VC. Only the packets if the protocols
mentioned in this field can lead to Auto detection. This field is
meaningful only when autostatus flag as enable.
Type: Create － Optional
Modify － Optional
Default value: 1
This field specifies that if the encap type detected is VCMux, the user
can configure to build a specific protocol stack automatically. It can only
be present with the autostatus flag as enable. In case of a conflict with
IDL series User Guide
Advertisement
Table of Contents
