Table of Contents
Advertisement
darpfailedhandling Drop |
TransparentForward |
FloodTrustedPorts
drabcasttoucast Enable | Disable
bngmac <bngmac-val>
drastatus Enable | Disable
piastatus Enable | Disable
666
Default value: enable
This specifies the action to be taken on an ARP packet received on
this VLAN for which it is not possible to determine a single port
using (VLANId, IP address) to bridge port mapping learnt using
DRA. If the value is drop, the ARP packet will be dropped. If the
value is Transparent Forwarding, the ARP packet will be forwarded
as per the normal bridging. If the value is FloodTrustedPorts, the
ARP packet will be forwarded as per the normal bridging, but only
on ports that are trusted.
Type: Create -- Optional
Modify -- Optional
Default value: FloodTrustedPorts
This Parameter is used to configure whether DHCP broadcast
packet received for this vlan will be converted to unicast packet or
not.
Type: Create -- Optional
Modify -- Optional
Default value: Disable
This is used to configure BNG Mac address of this VLAN. If VLAN
is configured to convert DHCP broadcast packets to Unicast
packets,then this MAC address is used as destination MAC
address.
Type: Create -- Optional
Modify -- Optional
Default value: "\xff\xff\xff\xff\xff\xff"
This Parameter specifies the status of DRA whether it is enabled
for this Vlan or not. If enabled DRA will Act as per the port
configuration on which DHCP packet is received. If disabled DRA
will not perform any action on the DHCP packets received over this
vlan.
Type: Create -- Optional
Modify -- Optional
Default value: Enable
This Parameter specifies the status of PIA whether it is enabled for
this Vlan or not. If enabled PIA will Act as per the port configuration
on which PPPoE packet is received. If disabled PIA will not
perform any action on the PPPoE packets received over this vlan.
Type: Create -- Optional
Modify -- Optional
Default value: Enable
IDL series User Guide
Advertisement
Table of Contents
