Table of Contents
Advertisement
Session Id
AC Mac Addr
Mac Addr Prof
Service Name Profile
AC Name Prof
Eth Pkt Type
Nature
Oper Status
Admin Status
References:
PPPoE session config related commands.
IP DSLAM
Session Id for the session given only in case a static
session is being created.
MAC address of the remote AC given only in case a static
session is being created.
Profile Id for self MAC addresses. The profile for the same
is created using the PPPoEMacAddrProfileTable.
Profile Id related to Service Name for the Session based on
which the AC is selected.The Profile for the same is
created using the PPPoESessionProfileTable. A value of
"any" means no specific service is needed to select an AC.
A value of "anyconfigured"means any configured service
name profile can be used for selecting an AC.
Profile Id related to AC Name for the Session based on
which the AC is selected. The Profile for the same is
created using the PPPoEAcProfileTable. A value of "any"
means no specific AC is needed for establishing a session
on the WAN side. A value of "anyconfigured"means any
configured AC name profile can be used for selecting an
AC.
This specifies the type of the packet.
Specifies if the interface is dynamic or static in nature. The
session is assumed to be in established state when the
interface is static in nature.
The actual/current state of the interface. It can be either up
or down.
The desired state of the interface. It may be either Up or
Down.
505
Advertisement
Table of Contents
