Reset Stp Stats - Planet IP DSLAM IDL-2400 User Manual

5.6.12.3 Reset stp stats

Description:
Use this command to reset STP global statistics.
Command Syntax:
reset stp stats
Parameters:
Name
Priority <priority-val>
Maxage
<maximum-age>
htime <hello-time>
Fdelay <forward-delay>
Enable|disable
IP DSLAM
Description
The value of the write-able portion of the Bridge ID,i.e.,the
first two octets of the (8 octet long) Bridge ID. The other
(last) 6 octets of the Bridge ID are given by the value of
dot1dBaseBridgeAddress.
Type : Optional
Valid values: 0 - 65535.
The maximum age of Spanning Tree Protocol information
learned from the network on any port before it is discarded,
in units of seconds. This is the actual value that this bridge
is currently using.
Type : Optional
Valid values: 6 - 40.
The amount of time between the transmission of
Configuration bridge PDUs by this node on any port when it
is the root of the spanning tree or trying to become so, in
units of second. This is the actual value that this bridge is
currently using.
Type : Optional
Valid values: 1 - 10
This is the actual time value, measured in units of seconds,
controls how fast a port changes its spanning state when
moving towards the Forwarding state. The value
determines how long the port stays in each of the Listening
and Learning states, which precede the Forwarding state.
This value is also used, when a topology change has been
detected and is underway, to age all dynamic entries in the
Forwarding Database.
Type : Optional
Valid values: 4 - 30
Spanning Tree Protocol to be enabled on the Bridge or not.
Spanning Tree Protocol can not be enabled in Stacked Vlan
199