Table of Contents
Advertisement
Output Fields:
FIELD
Ifname
IntervalNumber
Rx Blocks
Tx Blocks
Corrected Blocks
Uncorrected Blocks
GsNoCellDelineation
GsHeaderErrorCheck
Valid Data
AturChanIntvlNcds
AturChanIntvlLcds
References:
atur interval related commands
5.9.12 ADSL ATUR Channel Commands
5.9.12.1 Get adsl atur channel
Description:
Use this command to get.
Command Syntax:
get adsl atur channel [ifname <interface-name>]
Parameters:
Name
ifname
<interface-name>
IP DSLAM
Description
The ADSL interface name
Count from 1 through 96, of 15 minute intervals.
Count of all encoded blocks received on this channel, during this interval.
Count of all encoded blocks transmitted on this channel, during this interval.
Count of all encoded blocks received with errors that were corrected on this
channel, during this interval.
Count of all encoded blocks received with errors that cannot be corrected,
on this channel, during this interval.
GlobespanVirata parameter. Count of no cell delineation (ncd) on this
channel during this interval.
Conexant parameter. Header error check counter (HEC) on this channel,
during this interval.
This indicates if the data for this interval is valid.
Count of all blocks received with NCD errors on this channel during this
interval.(length = 4 bytes).
Count of all blocks received with LCD errors on this channel during this
interval.(length = 4 bytes).
Description
The ADSL interface name
Type: Get － Mandatory
Valid values: dsli-0 - dsli-23
257
Advertisement
Table of Contents
