Igmpsnoop Mvlan Config Commands; Get Igmpsnoop Mvlan Config - Planet IP DSLAM IDL-2400 User Manual

Robustness Variable
Igmp Snoop Status
Version Mask
Report Suppression
Status
Proxy Report Status
StartUp QryCount
Last Member QryCount

5.14.2 Igmpsnoop mvlan config Commands

5.14.2.1 Get igmpsnoop mvlan config

Description:
Use this command to get.
Command Syntax:
get igmpsnoop mvlan config [grpipaddr <grpipaddr-val>] [srcipaddr
<srcipaddr-val>] [vlanid <vlanid-val> | none]
IP DSLAM
sent in response to Leave Group messages, and is also the
amount of time between Group-Specific Query messages. The
value of this parameter may be tuned to modify the leave latency
of the network. A reduced value results in reduced time to
detect the loss of the last member of a group. The unit of this
parameter is one-tenth of second.
This parameter allows tuning for the expected packet loss on a
subnet. The IgmpSnooping module is robust to [RobustnessVar]
packet losses.
This parameter specifies whether Igmp Snooping needs to be
enabled in the system.
This parameter controls which versions of IGMP are currently
supported at Columbia. Depending on the version mask, IGMP
messages of unsupported version, will be dropped
Report Suppression is enabled or not.
This parameter controls whether proxy reporting will be
supported at the global level.
This parameter specifies the number of General Queries sent on
receiving Port Up topology change trigger, separated by the
StartupQryInterval
This parameter specifies the number of Group-specific or
Group-and-Source-specific Queries sent before assuming there
are no listener for this Group or Group-Source pair.
451