Table of Contents
Advertisement
Set Base type
Shift Count
Multiplier
Description
5.13.14 Clfr tree profile Commands
5.13.14.1 Get clfr tree profile
Description:
Use this command to get.
Command Syntax:
get clfr tree profile [tname <tname-val>] [pid <pid-val>]
5.13.14.2 Create clfr tree profile
Description:
Use this command to create.
Command Syntax:
create clfr tree profile tname <tname-val>pid <pid-val>pname <pname-val>
[isroot <isroot-val>]
5.13.14.3 Delete clfr tree profile
Description:
Use this command to delete.
Command Syntax:
get clfr tree profile tname <tname-val> pid <pid-val>
IP DSLAM
For other actions this field is not valid.
SetBaseTyp, is used to specify whether the base off set is to be set to an
absolute value, or some value is to be added to existing base offset value to
calculate new base offset value or the new base offset value is to be computed
using some value in the packet. This field is valid only if the ActVal is SetBase.
ShiftCount is the number of times the Value in the packet is to be shifted before
multiplying it with the Mplr. This field is valid only if the ActVal is SetBase. Value
32 is used to set shift count to an invalid value.
Multiplier is used to multiply the value shifted by ShiftCount. It is used to calculate
the new base offset. This field is valid only if the ActVal is SetBase.
Description of the profile node. If the ActVal is FwdToCtl or CpToCtl then this field
is mandatory and it can be used by the applications to receive the packets
coming from control plane because of this node.
367
Advertisement
Table of Contents
