Planet IP DSLAM IDL-2400 User Manual page 167

autosensetriggertype
dynamic |
opstatechange
ctlpktgroupid
ctlpktgroupid | none
Example:
$ create atm vc intf ifname aal5-0 lowif atm-0 vpi 10 vci 10 enable aal5 pvc
a5txsize 1536 a5rxsize 1536 llcmux mgmtmode data autosupportedprot pppoa
eoa autovcmuxforcedprot pppoa autosensetriggertype dynamic ctlpktgroupid none
Output:
Verbose Mode On
Entry Created
VC IfName
VPI
Admin Status
Aal5 Tx Size
AAL Type
channel
MgmtMode
IP DSLAM
autoSupportedProtocols, its value will override.
Type: Create － Optional
Modify － Optional
Default value: none
This field specifies at what time autodetection of Encapsulation type or
higher protocol layers is to be done - all the time or only when
Operational Status of ATM VC is changed to UP. If its value is
'dynamic', then detection can happen anytime a packet is received. If its
value is 'opstatechange', then autodetection happens only when
Operational status of ATM VC changes to UP. This field is not valid if
encaptype is Ethernet.
Type: Create － Optional
Modify － Optional
Default value: dynamic
The Control packet instance group associated with this VC. The flows
for this interface shall be mapped to control packet instances as
mapped for the flows corresponding to the groupid configured in ctrlpkt
group info command. If this group does not have entries for some of the
flows, then those flows shall be mapped to the ctlpktinstid of ATM port,
for which this VC is being created. If the group id is 0, then all the flows
shall be mapped to ctlpktinstid of ATM port, for which this VC is being
created.
Type: Create － Optional
Valid values: 0 -50
Default value: 0
: aal5-0 Low IfName
: 0 VCI
: Up Oper Status
: 1536 Aal5 Rx Size
: AAL5
: Interleaved Last Change(sec) : 0
: Data
: atm-0
: 35
: Down
: 1536
AAL5 Encap : llcmux
Row Status : active
167