Table of Contents
Advertisement
SBVar Index
Node Priority
5.13.10 Clfr tree branch Commands
5.13.10.1 Get clfr tree branch
Description:
Use this command to get.
Command Syntax:
get clfr tree branch [tname <tname-val>] [pid <pid-val>] [nodeid <nodeid-val>]
[brtype <brtype-val>]
5.13.10.2 Create clfr tree branch
Description:
Use this command to create.
Command Syntax:
create clfr tree branch tname <tname-val>pid <pid-val>nodeid
<nodeid-val>brtype <brtype-val>childpid <childpid-val>
5.13.10.3 Delete clfr tree branch
Description:
Use this command to delete.
Command Syntax:
create clfr tree branch tname <tname-val>pid <pid-val>nodeid
<nodeid-val>brtype <brtype-val>
IP DSLAM
because of this node.
This specifies setbase variable index. This field is valid only if
'SetBaseType' is 'SetFromVar'. 'L2Start' is read-only containing
Layer 2 header start offset. 'L3Start' is read-only containing
Layer 3 header start offset. It should be ensured that packet is IP
packet before using 'L3Start' value
This specifies the priority of profile node. Based on this priority
value, the profile node is created in fast or slow memory. In case
priority is specified as 'AsInTree', node priority will be same as
specified in the tree.
355
Advertisement
Table of Contents
