Enabling Multiple Hosts; Disabling Multiple Hosts; X Protocol Over Ip Dslam - Planet IP DSLAM IDL-2400 User Manual

Enabling Multiple Hosts

You can enable a specific port to allow multiple users. When a port is enabled for
multiple users, and a host that is connected to that port is authorized successfully,
any host (with any MAC address) is allowed to send and receive traffic on that port.
If you connect multiple hosts to that port through a hub, you can reduce the
security level on that port.
To enable access for multiple users on a specific port, perform this task in
privileged mode:
Enable multiple hosts on a specific port.

Disabling Multiple Hosts

You must disable access for multiple users on any port where it is enabled.
To disable access for multiple users on a specific port, perform this task in
privileged mode:
Disable multiple hosts on a specific port.

802.1X Protocol over IP DSLAM

In 802.1x application, the IP DSLAM acts as the pure Ethernet packets transport
system. The 802.1x packets pass through the IP DSLAM without further operation
(see below figure)
IP DSLAM
Task
create port dot1x mod/port multiple-host enable
Task
create port dot1x mod/port multiple-host disable
Command
Command
705