Table of Contents
Advertisement
Output Fields:
Field
MacAddress
No. of Ports
Base Type
Aging TimeOut
Slaveaging TimeOut
Floodsupport
Bcastsupport
Mcastsupport
Mcastdrop
NetAgingTimeout
Full Bridging Status
208
Description
The MAC address used by this bridge, when it must be
referred to, in a unique fashion. It is the address of one of the
Ethernet ports.
The maximum number of ports that can be controlled by this
bridge.
Indicates what type of bridging this bridge can perform. It is
always Transparent Bridging or STP.
The timeout period, in seconds, for aging out dynamically
learned forwarding information from CPEs. The value 0 can
be configured when aging is to be stopped.
The timeout period, in seconds, for aging out dynamically
learned forwarding information learned from the slave device.
The recommended value for this is more than or equal to the
value for dot1dTpAgingTimeOut. The value 0 can be
configured when aging is to be stopped.
This is used to specify whether the unknown unicast packets
are to be flooded or not. The value for this is used along with
per vlan configuration for flood support to determine if
flooding has to be done for unknown unicast packet.
This is used to specify whether the broadcasting is supported
or not. The value for this is used along with per vlan
configuration broadcast support, to determine if broadcasting
has to be done for the broadcast packet.
Used to specify whether the multicast is supported or not.
Used to specify whether the multicast packets are to be
dropped, or to be forwarded, if multicast is not supported.
This is only valid if dot1dTpMcastSupport is false.
The timeout period, in seconds, for aging out dynamically
learned forwarding information from NET side port. This is
used only for full bridge configuration. The recommended
value of net aging timeout should be greater than that of
dot1dTpAgingTimeOut.
This specifies the current state of full bridging on the bridge.
Thebridge can be set to residential bridging, restricted full
bridging or unrestricted full bridging. In residential bridging, all
packets from a CPE side port are sent to Net side port without
doing a lookup in the forwarding table. In restricted full
bridging, there is a lookup and a packet coming from a CPE
IDL series User Guide
Advertisement
Table of Contents
