Table of Contents
Advertisement
Output Fields:
Field
ifname
GroupId
MinAggrRateUpstrm
MinAggrRateDnstrm
DiffDelayTolUpstrm
DiffDelayTolDnstrm
AsmProtocol
SidFormat
MaxRxBitRateRatio
LinkHecThreshold
CtrlVpi
CtrlVci
NoOfLinksUpForGrpUp
AsmIrlThreshold
MaxAtmPortUsRate
Oper Status
IP DSLAM
Description
This specifies the interface index used for the ATM Based Multi pair Bonding
type of interfaces. Valid Value is abond-X. Modification and deletion is not
possible if interface is enabled
This specifies the group id configured for this interface. This field is configured
statically when the bonded group is provisioned and must not be changed
while the group is in service. These fields may be used by an operator to help
identify mis-configuration or to assist in management or debugging of the link.
Minimum Aggregate Data Rate in bits per second in Upstream direction.
Minimum Aggregate Data Rate in bits per second in Downstream direction.
The maximum differential delay among member links in a bonding group in
Upstream direction.
The maximum differential delay among member links in a bonding group in
downstream direction.
This parameter specifies whether Autonomous Status Messages will be
exchanged between CO and CPE. If it is disabled then the group would be
bonded statically and CO would assume CPE to know all the configuration
parameters like SID format, number of links in the bonded group and the links
participating in bonding. If it is enabled then CO would inform all these
parameters to CPE using Autonomous Status Messages.
SID Format: 8 bit or 12 bit SID. Only 8 bit format is being supported
The maximum bit rate ratio among member links in a bonding group in
upstream direction.
HEC Error percentage of the link upstream rate which will act as Threshold for
link to be part of group in Rx direction
Control Channel VPI: VPI value being used for Sending and Receiving ASM
Messages
Control Channel VCI: VCI value being used for Sending and Receiving ASM
Messages
This field specifies the number of links required to be up for bonding to start
ASM protocol
IRL Threshold for ASM messages
Maximum ATM port Upstream Rate
The actual/current state of the interface. It can be either up or down.
125
Advertisement
Table of Contents
