Table of Contents
Advertisement
GsExpandedExchange
GsEscapeFastRetrain
GsFastRetrain
GsBitSwap
GsNtr
GsAlctlUsVer
GsUseCustomBin
GsFullRetrain
GsPsdMaskType
GsEraseProfiles
GsExtRsMemory
ParamHybridLossTestStart
GsParamHybridLossTestEnd
GsDmtTrellis
GslTriggerMode
Type
GsDnBinUsage
ParametricTestInputFile
Data Boost
Upstream PSD
Conf PM Mode
Conf PML0 Time(sec)
Conf PML2 Time(sec)
298
T1.413 parameter that Enables/Disables EES
This parameter enables/disables escape to the fast retrain
capability
This parameter enables/disables the fast retrain capability.
Currently supported only in G.lite mode.
This parameter enables/disables bit swapping
This parameter enables/disables NTR on a per chip basis
For T1.413 demo purposes only
This parameter enables/disables user selection which of the 511
bins will be enabled for upstream and downstream transmission.
Indicates enable/disable of auto retrain capability
This parameter selects the PSD mask option to be used
This parameter enables/disables the ability to erase all fast retrain
profiles at startup
Indicates whether customer's Hardware uses external RS RAM
Start bin for range of bins to be measured. The default value
mentioned is an indicative value only, for exact value refer to
document number DO-400523-AN and DO-401163-AN.
End bin for range of bins to be measured.
This parameter enables/disables trellis coding. Trellis coding
should always be enabled for its clear performance advantage.
The type of event that triggers a fast retrain
This object is used to configure the ADSL physical line mode.
'1' in bit position indicates usage of corresponding bin,whereas a
'0' disables usage of corresponding bin.
Indicates Name of the Input file from which to take the Mask Array
Size, lower and upper mask Array. Null string means no file is
specified
Conexant parameter that enables/disables DataBoost option.
Conexant parameter that sets the upstream PSD to be either
extended or standard. Used for GSpan Plus only.
PM-related parameter used by the ATU-C to set the allowed link
states. Both bit values can be given simultaneously in the input.
Additional value to disable pmmode is disable, which is equal to 0.
PM configuration parameter, related to the L2 low power state.
This parameter represents the minimum time (in seconds)
between an exit from the L2 state and the next entry into the L2
state. It ranges from 0 to 255 seconds.
PM configuration parameter, related to the L2 low power state.
This parameter represents the minimum time (in seconds)
IDL series User Guide
Advertisement
Table of Contents
