Table of Contents
Advertisement
Max Access
Concentrators
Max Src MAC
Addresses
Vlan Mode
S Vlan Protocol Id
T Vlan Protocol Id
T Vlan Id
AbondGlbCtrlVpi
AbondGlbCtrlVci
AbondGlbSidFmt
Ridcap
626
capability is ivlcapable then svmcapable is not a valid value. If
the device capability is neither ivlcapable nor svmcapable then
the only valid value for this field is none. If the device capability
is ivlcapable or svlcapable then this field can't have value none.
ivmcapable and svmcapable can't be set together.In case of
Stacked Vlan Mode this shall apply to Virtual Vlans.
It denotes the maximum number of Access Concentrators
supported.
It denotes the maximum number of Source MAC addresses that
can be used across the different PPPOE and IPOE interfaces.
Vlan Mode
This specifies the ProtocolId value to be used for Stacked
Vlan/Service Vlan/Provider Vlan/Second Vlan tag. It is
recommended to keep the value for this different from
ProtocolId value defined for 802.1q Vlan(0x8100). This attribute
is applicable only in 'VLAN Stacking mode'.
This specifies the ProtocolId value to be used for Stacked
Vlan/Service Vlan/Provider Vlan/Second Vlan tag. It is
recommended to keep the value for this different from
ProtocolId value defined for 802.1q Vlan(0x8100). This attribute
is applicable only in 'VLAN Stacking mode'.
This specifies the ProtocolId value to be used for Stacked
Vlan/Service Vlan/Provider Vlan/Second Vlan tag. It is
recommended to keep the value for this different from
ProtocolId value defined for 802.1q Vlan(0x8100). This attribute
is applicable only in 'VLAN Stacking mode'.
This VPI value will be used for the control channel which will be
created to run the ATM based multi pair bonding protocol. This
is a system wide parameter and applies to all the abond group
interfaces which can be created in the system. Change in this
value will be applied at next boot only.
This VCI value will be used for the control channel which will be
created to run the ATM based multi pair bonding protocol. This
is a system wide parameter and applies to all the abond group
interfaces which can be created in the system. Change in this
value will be applied at next boot only.
This SID Format value will be used for all the Abond Group
Interfaces which can be created in the system. Change in this
value will be applied at next boot only.
RID refers to the Routing Information Database. This database
IDL series User Guide
Advertisement
Table of Contents
