5.9.9 ADSL ATUC Trap Commands
5.9.9.1 Get adsl atuc traps
Description:
This command is used to get.
Command Syntax:
get adsl atuc traps [ifname <interface-name>
Example:
$ get adsl atuc traps ifname dsl-0
Output:
Ifname
Lofs Thresh Trap : 0
Lols Thresh Trap : 0
ESs Thresh Trap : 1
Rate Change Trap : 0
PM State Trap
Output Fields :
FIELD
Ifname
Lofs Thresh Trap
Loss Thresh Trap
Lols Thresh Trap
Lprs Thresh Trap
ESs Thresh Trap
Init Failure Trap
Rate Change Trap
Gs OpState Trap
PM State Trap
Command Failure Trap
254
: dsl-0
Loss Thresh Trap
Lprs Thresh Trap
Init Failure Trap
Gs OpState Trap
: 2
Command Failure Trap : 2
Description
The IfIndex of DSL port.
Loss of Framing 15-minute interval threshold reached (length = 4 bytes).
Loss of Signal 15-minute interval threshold reached (length = 4 bytes).
Loss of Link 15-minute interval threshold reached (length = 4 bytes).
Loss of Power 15-minute interval threshold reached (length = 4 bytes).
Errored Second 15-minute interval threshold reached (length = 4 bytes).
ATU-C initialization failed. Refer to adslAtucCurrStatus for potential reasons
(length = 4 bytes).
The ATU-Cs transmit rate has changed (RADSL mode only) (length = 4 bytes).
Op State change (length = 4 bytes).
PM state change trap used for ADSL2/ADSL2plus PM operation. This trap is not
valid for ADSL mode.
When the APIs fail to send a customer command to the DSP, the customer is
notified by a new trap and they need to re-issue the command.
: 1
: 1
: 1
: 1
IDL series User Guide