Table of Contents
Advertisement
Example:
$ create atm vcaggr map mapid 1 vc aal5-0 dnstrmpriolist 1 3 7 upstrmdefprio 2
upstrmregenprio 2
Output:
Verbose Mode On
Entry Created
VC map Id
Up Stream Default Priority : 2
Downstream priority Map
Verbose Mode Off:
Entry Created
Output Fields:
Field
VC map Id
VC Intf
Up Stream Default
Priority
Up Stream Regen
Priority
Downstream priority
Map
IP DSLAM
: 1
Up Stream Regen Priority : 2
: 1 3 7
Description
It contains the Id of VcAggregation Map. The VcAggrMap contains
the list of VCs being aggregated and the associated priorities in
downstream and upstream directions. Once the VC aggregation
interface is created with the a MapId, no more entries can be
created in the VcAggrMap table for that MapId
Name of the VC to be part of aggregation.
Priority parameter to be used for tagging the untagged upstream
traffic coming on a VC. Regeneration of priority at bridge level will
be done on the basis of this priority.If value None is specified, then
bridge port's defprio will be used for tagging the untagged packets
Priority parameter to be used for retagging the tagged upstream
traffic coming on a VC.Regeneration of priority at bridge level will
be done on the basis of this priority.If value None is specified, then
bridge port's priority regeneration map will be used.
This field specifies the downstream priorities with which the
specified VC interface shall be associated under a VC
Aggregation interface. This field is used for demultiplexing
downstream traffic. A VC can be mapped to multiple priorities. But
not two VCs can be mapped to same priority. Value None has
special significance. It specifies that this VC is part of VC
Aggregation interface but no priority is mapped to it.
VC Intf
: aal5-0
647
Advertisement
Table of Contents
