Table of Contents
Advertisement
atucconfmininp Inp0 |
InpPoint5 | Inp1 | Inp2 |
InpAuto | Inp4 | Inp8 | Inp16
atucpml2entrythreshrate
<atucpml2entrythreshrate-val
>
atucpml2exitthreshrate
<atucpml2exitthreshrate-val>
atucpml2entryratemintime
<atucpml2entryratemintime-v
al>
atucgscabinethsenable
Disable | Enable
atucgsseltlooptype
RealCable | Dls90 | Dls400
atucgsrxstartbinu1
<atucgsrxstartbinu1-val>
atucgsrxendbinu1
<atucgsrxendbinu1-val>
gspsdmaskdsenable
PsdMaskDisable |
PsdMaskEnable |
PsdMaskEnableMod
gspsdmaskusenable
PsdMaskDisable |
PsdMaskEnable |
PsdMaskEnableMod
psdmaskdsfallbackenable
False | True
290
Parameter used to specify the minimum impulse noise protection for
the downstream bearer channel.
Type: Modify -- Optional
PM config param. L2 state entry data rate.
Type: Modify -- Optional
Valid values: 0 - 0xffffffff
PM config param. L2 state exit data rate.
Type: Modify -- Optional
Valid values: 0 - 0xffffffff
PM config param.Min L2 entry rate time
Type: Modify -- Optional
Valid values: 900 - 65535
Enable/Disable HS tones in Cabinet mode
Type: Modify -- Optional
Conexant parameter that is used to specify the loop type for SELT. The
default value mentioned is an indicative value only.
Type: Modify -- Optional
Conexant parameter that specifies lowest bin number allowed for Rx
signal in G.Span Plus SUQ mode. By selecting the receive start and
end bin numbers, the user can limit the bins for special
configurations.(length = 4 bytes)
Type: Modify -- Optional
Conexant parameter that specifies highest bin number allowed for Rx
signal in G.Span Plus SUQ mode. By selecting the receive start and
end bin numbers, the user can limit the bins for special
configurations.(length = 4 bytes)
Type: Modify -- Optional
Conexant parameter that is used to configure the switching point
between DBM-OL and XOL.(length = 4 bytes)
Type: Modify -- Optional
Conexant parameter used to enable the Mask on Demand(MoD)
feature in the upstream direction. It is available only for ADSL2 Annex A
ONLY.(length = 4 bytes)
Type: Modify -- Optional
Conexant parameter used to enable Mask on Demand (MoD) fallback
mode. When enabled, the system chooses MoD or the base ADSL2
depending upon the downstream rate. It is avaiable only for ADSL2
Annex A.(length = 4 bytes)
Type: Modify -- Optional
IDL series User Guide
Advertisement
Table of Contents
