Table of Contents
Advertisement
EthType
Num of LBRams
Num of Chips
Num of Ports
Interface Type
Chip Type
Serial Number
Vendor Id
Version Number
Base Addr
LBRam
Logical
To
Port Mapping
No of UARTs
HSSL Port Id
Baud Rate
Data Bits
Stop Bit
Parity
UART Mode
Application Type
5.25.7 System reboot info Commands
5.25.7.1 Get system reboot info
Description:
This command is used for displaying a list of reboot failures that were encountered
when the system was trying to come up.
Command Syntax:
get system reboot info [numentries]
616
This specifies the Defines the ethernet types – data
, mgmt, or both. It is a bitmask.
This specifies the number of LBRams in the system.
This specifies the number of Chips in the system.
This specifies the number of Ports per Chip in the system.
This specifies the InterfaceType. Following are the values it
can take – Host Bus, PCI, Utopia
This specifies the Type of Chip – G24, G16, and octane.
This specifies the vendor specific string that identifies the
vendor equipment.
This specifies the binary vendor identification field.
This specifies the vendor specific version number
sent by this ATU as part of the initialization message
This specifies the base address of the chip.
This specifies the LBRam associated with the chip
Physical
This specifies the Logical To Physical Port Mapping.
This specifies the number of UARTs configured.
This specifies the HSSL port to be used for UART.
This specifies the Baud Rate of the port
This specifies the number of data bits to be used
This specifies the stop bits used on HSSL – 1, 2, 1.5
This specifies the parity used on HSSL – even, odd, none
This specifies the UART Mode – polling, interrupt based
This specifies the application name using this UART.
IDL series User Guide
Advertisement
Table of Contents
