Planet IP DSLAM IDL-2400 User Manual page 297

Fast Max Tx Rate(bps)
Intl Max Tx Rate(bps)
Max Intl Delay(ms)
GsTxStartBin
GsTxEndBin
GsRxStartBin
GsRxEndBin
GsMaxBitsPerBin
GsMaxDCo
GsRxBinAdjust
GsAdi2x
GsInitiate
GsTxPowerAtten
GsCodingGain
GsRsFastOvrhdDown
GsRsIntCorrectionDown
GsRsFastOvrhdUp
GsDrStby
IP DSLAM
bps. Also refer to 'adslAtucConfRateChanRatio' for information
regarding RADSL mode and refer to ATU-R transmit rate for
ATU-C receive rates.
Configured Maximum Transmit rate for 'Fast' channels, in bps.
Also refer to 'adslAtucConfRateChanRatio' for information
regarding RADSL mode and ATU-R transmit rate for ATU-C
receive rates.
Configured Maximum Transmit rate for 'Interleave' channels, in
bps. Also refer to 'adslAtucConfRateChanRatio' for information
regarding RADSL mode and ATU-R transmit rate for ATU-C
receive rates.
Configured maximum Interleave Delay for this channel.
Interleave delay applies only to the interleave channel and defines
the mapping (relative spacing) between subsequent input bytes at
the interleaver input and their placement in the bit stream at the
interleaver output. Larger numbers provide greater separation
between consecutive input bytes in the output bit stream, allowing
for improved impulse noise immunity at the expense of payload
latency.
The lowest bin number allowed for Tx signal.
The highest bin number allowed for Tx signal.
The lowest bin number allowed for Rx signal.
The highest bin number allowed for Rx signal.
The maximum Rx number of bits per bin.
Maximum interleaving depth supported by the customer's
hardware
This parameter employs Rx Start/End bin settings
For non-standard compliant ADI CPE
Specifies which end initiates startup. It is also used to send a
C-tone to the remote unit.
The value in dB of Tx power attenuation
Sets the coding gain in dB increments
This parameter sets the percentage overhead for the downstream
fast buffer. RS can also be disabled.
This parameter sets the correction time for the downstream
interleaved buffer.RS can also be disabled.
This parameter sets the percentage overhead for the upstream
fast buffer.RS can also be disabled.
This parameter provides the ability to disable power to the line
driver
297