Power Supply; Chassis Specifications - Cisco AS5350XM Installation Manual

Power Supply

For details on cards, installation, and troubleshooting, see the Cisco AS5350XM and Cisco AS5400XM
Note
Universal Gateways Card Installation Guide. This document is available on Cisco.com. (See the
"Obtaining Documentation" section on page
Power Supply
The power system consists of a single input AC or DC power supply or a dual input (redundant) AC or
DC power supply. Cooling is provided by two self-contained fans.
Each power module is capable of supplying a maximum DC load of 150 watts, and is composed of four
independent output voltages: 3.3V, 5V, 12V, and –12V. AC input units have power factor correction, and
low total harmonic distortion. Power failures are reported through environmental monitoring software.
Check the power at your site to ensure that you are receiving "clean" power (free of spikes and noise).
Install a power conditioner if necessary.
The grounding architecture for the Cisco AS5350XM universal gateway is isolated DC return (DC-I).
Note

Chassis Specifications

Table 1-1
Description
Dimensions (H x W x D)
Weight
Processor
Operating temperature
Operating humidity
Noise level
Input voltage, AC power supply
Current
Frequency
Power factor
Input AC power
Input voltage, DC power supply
Maximum input current
Input DC power
WAN interface options
Serial interfaces (for backhaul WAN support)
LAN interface options
Cisco AS5350XM Universal Gateway Chassis Installation Guide
1-4
Chassis Specifications
xiv.)
Specification
1.7 x 17.5 x 20.5 in. (4.39 x 44.45 x 52.07 cm)
22 lb maximum (10 kg)
250 MHz
32 to 104°F (0 to 40°C)
5 to 95%, noncondensing
1
55 dB @ 3 ft (0.914 m)
2
100 to 240 VAC ; –10%, +6% tolerance
2.0 to 1.0 A; dependent on load
50/60 Hz
0.80 to 0.90
140 to 170W; dependent on load
–48/-60 VDC, –10%, +10% tolerance
3 A (1.5-2.0 A typical)
150 W (maximum)
T1 and E1 dial feature cards
2 serial line interfaces
2 Gigabit Ethernet 10/100/1000BASE-T
(RJ-45) ports
Chapter 1 Overview
OL-6417-02