2T Serial Ports; Alarm Port; Bits Port - Cisco AS5350XM Installation Manual

Chapter 2 Preparing to Install the Cisco AS5350XM Universal Gateway
Auxiliary Port
The Cisco AS5350XM universal gateway includes an EIA/TIA-232 asynchronous serial auxiliary port
(RJ-45) that supports flow control. Depending on the cable and the adapter used, this port will appear as
a DTE or DCE device at the end of the cable. Your universal gateway arrives with a cable and an adapter
to connect a modem to the auxiliary port. To connect a modem to the auxiliary port, use the RJ-45
rollover cable with the male RJ-45-to-DB-25 adapter (labeled MODEM).
For detailed information about connecting devices to the auxiliary port, see
Cisco AS5350XM Universal Gateway."
port pinouts.

2T Serial Ports

Two high-speed 12-in-1 serial ports on the rear panel of the Cisco AS5350XM universal gateway provide
backhaul WAN and IP support.
The following types of serial interface standards (in DTE or DCE devices) are supported:
•
•
•
•
•
•
Each interface supports up to 8 Mbps.

Alarm Port

The three pins on the alarm port are connected to the output of a relay. This relay is controlled by system
software. To configure the alarm port, see the Cisco AS5350XM and Cisco AS5400XM Universal
Gateways Software Configuration Guide. This document is available on Cisco.com. (See the
Documentation" section on page
With the alarm port connected and configured, Cisco IOS software polls the universal gateway every one
second to detect the failure events that occur and turns on the alarm when it detects any failure event.
See

BITS Port

The BITS port is a coaxial interface that provides external synchronized clocking through a timing signal
generator (TSG). To configure the BITS port, see the Cisco AS5350XM and Cisco AS5400XM Universal
Gateways Software Configuration Guide. This document is available on Cisco.com. (See the
Documentation" section on page
specifications.
OL-6417-02
EIA/TIA-232
EIA/TIA-449
EIA/TIA-530
EIA/TIA-530A
EIA/TIA-X.21
ITU-T V.35
Appendix C, "Cabling Specifications,"
See Appendix C, "Cabling Specifications,"
xiv.)
for pinouts and cable specifications.
xiv.) See Appendix C, "Cabling Specifications,"
Cisco AS5350XM Universal Gateway Chassis Installation Guide
Preparing to Connect to a Network
Chapter 3, "Installing the
for cable and
"Obtaining
"Obtaining
for pinouts and cable
2-5