Connection Of The Cable; Points To Note When Turning Off The Main Power; Attaching Other Parts - Canon Color iR C3480 Service Manual

Chapter 2
4) Close the front door.

2.2.5 Connection of the Cable

Color iR C3380G / Color iR C2880G / Color iR C3380i / Color iR C3380 /
Color iR C2880i / Color iR C2880 / iR C3480 / iR C3480i / iR C3080 / iR
C3080i / iR C2550
1) Fix the reader communication cable [2] in place with the 3 wire saddles
[1] to connect the connector of the both sides to the host machine.
[1]
F-2-30
2) Connect the power cable (for outlet) of the host machine.
3) Turn on the main power switch.

2.2.6 Points to Note When Turning Off the Main Power

Color iR C3380G / Color iR C2880G / Color iR C3380i / Color iR C3380 /
Color iR C2880i / Color iR C2880 / iR C3480 / iR C3480i / iR C3080 / iR
C3080i / iR C2550
How to Turn Off the Main Power
When turning off the main power, be sure to go through the following steps
to protect the hard disk:
1) Hold down the control panel power switch for 3 sec or more.
2) Follow the instructions on the shutdown sequence screen to let the main
power switch be ready to turn off.
3) Turn off the power switch.
4) Disconnect the power plug.

2.2.7 Attaching Other Parts

Color iR C3380G / Color iR C2880G / Color iR C3380i / Color iR C3380 /
Color iR C2880i / Color iR C2880 / iR C3480 / iR C3480i / iR C3080 / iR
C3080i / iR C2550
<Service book container>
1) Remove the release paper of the double-sided tape on the rib area of the
service book container [1], and attach the service book container on the
bottom plate of the pedestal.
Do not attach the service container:
- Inside the machine.
- in the position onto which attachment of the service book container may
block off the louver area.
- in the position onto which attachment of the service book container may
block off the grip area.
2-12
0013-8405
[1] [2]
0013-8256
0013-8257
MEMO:
In case there is no pedestal, attach the service book container on the left
cover of the host machine.
<Touch Pen>
1) Place the touch pen [1] in the control panel.
[1]
<Lower Right Cover (Lower) >
Go through this procedure when double-deck pedestal is not installed.
1) Hook the claws in the order of [A] and [B], and attach the Lower right cov-
er (Lower) [1].
[A]
<Stamp (Model with DADF only) >
1) Open the DADF feeder cover [1] and separation guide [2].
[1]
F-2-31
F-2-32
[B]
[1]
F-2-33
[2]
F-2-34