Rep 22.5.1 Pinch Roll; Rep 22.5.2 Finisher Entrance Sensor - Xerox WorkCentre 5222 Service Manual

REP 22.5.1 Pinch Roll

Parts List on PL 22.5
Removal
To avoid personal injury or shock, do not perform repair or adjustment with electrical
power applied to the machine.
1. Remove the A-Finisher from the machine.
2. Remove the Compile Assembly. (REP
3. Remove the Pinch Roll. (Figure 1)
(1)Raise Springs (4) in the direction of the arrow.
(2)Remove Pinch Rolls (4).
Figure 1 Removing the Pinch Rolls (j0fa42224)
Replacement
1. Reverse the removal procedure for replacement.
Repairs and Adjustments
REP 22.5.1, REP 22.5.2
WARNING
(REP 22.1)
22.9.1)

REP 22.5.2 Finisher Entrance Sensor

Parts List on PL 22.5
Removal
To avoid personal injury or shock, do not perform repair or adjustment with electrical
power applied to the machine.
1. Remove the A-Finisher from the machine.
2. Turn over the A-Finisher.
3. Remove the Bottom Cover.
4. Remove the Connector Bracket.
(1)Release Clamps (3) and remove the wires.
(2)Disconnect Connectors (5).
(3)Remove Screws (2).
(4)Remove Connector Bracket.
Figure 1 Removing the Connector Bracket (j0fa42266)
February, 2008
4-186
WARNING
(REP 22.1)
(PL 22.2)
(Figure 1)
WorkCentre 5225, 5230
Launch Version