REP 12.1 Finisher Removal
Parts List on
PL
12.10,
PL
12.15,
12.35,
PL 12.40
and
PL 12.45
Removal
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
Take care during this procedure. Sharp edges may be present that can cause injury.
Before performing this procedure, refer to General Disassembly Precautions,
1.
Open the Finisher front door,
PL 12.10 Item
2.
Disconnect the Finisher interface harness,
3.
Remove the Finisher Stacker tray,
PL 12.45 Item
4.
Remove the Finisher
(Figure
1).
1
Release the latch.
2
Pull out the Finisher until it latches in the
second stop.
3
Release the latch again.
4
Remove the Finisher.
Figure 1 Removing the Finisher
WorkCentre WorkCentre 4150/4250/4260WorkCentre 4150/4250/42604150/
PL
12.20,
PL
12.25,
PL
WARNING
WARNING
CAUTION
GP
1.
PL 12.10 Item 18
from the machine.
1.
Replacement
Replacement is the reverse of the removal procedure.
12.30,
PL
10.
January 2016
4-165
Repairs and Adjustments
REP 12.1