Rep 7.1 Mec Unit - Tray Assembly - Xerox WorkCentre M20 Service Manual

REP 7.1 MEC Unit - Tray Assembly

Parts List on PL 8.11
Removal
WARNING
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
WARNING
Take care during this procedure. Sharp edges may be present that can cause injury.
CAUTION
Before performing this procedure, refer to General Disassembly Precautions, GP 10.
NOTE: If necessary, refer to GP 20 for the acronym list and cross reference lists of more com-
monly recognised part names.
1. Prepare to remove the MEC unit - tray assembly, Figure 1.
2
Separate the front and rear hinges by carefully
pulling the MEC unit - tray assembly away from
the machine.
Figure 1 Preparation
WorkCentre M20, 4118, FaxCentre 2218 Family
2. Remove the MEC unit - tray assembly and PMO - tray links, MP, Figure 2.
1
While holding the MEC unit - tray
assembly vertically, disengage the front
and rear PMO - tray links, MP.
Replacement
1
Replacement is the reverse of the removal procedure.
Fully open the MEC unit -
tray assembly.
December 2006
4-39
2
Remove the front and rear
PMO tray links, MP.
Figure 2 MEC unit - tray assembly removal
Repairs and Adjustments
REP 7.1