Spi Communication Using Dma (Direct Memory Addressing) - ST STM32F101 series Reference Manual

Advanced arm-based 32-bit mcus
Hide thumbs Also See for STM32F101 series:
Table of Contents

Advertisement

RM0008
25.3.9

SPI communication using DMA (direct memory addressing)

To operate at its maximum speed, the SPI needs to be fed with the data for transmission
and the data received on the Rx buffer should be read to avoid overrun. To facilitate the
transfers, the SPI features a DMA capability implementing a simple request/acknowledge
protocol.
A DMA access is requested when the enable bit in the SPI_CR2 register is enabled.
Separate requests must be issued to the Tx and Rx buffers (see
Figure
247):
In transmission, a DMA request is issued each time TXE is set to 1. The DMA then
writes to the SPI_DR register (this clears the TXE flag).
In reception, a DMA request is issued each time RXNE is set to 1. The DMA then reads
the SPI_DR register (this clears the RXNE flag).
When the SPI is used only to transmit data, it is possible to enable only the SPI Tx DMA
channel. In this case, the OVR flag is set because the data received are not read.
When the SPI is used only to receive data, it is possible to enable only the SPI Rx DMA
channel.
In transmission mode, when the DMA has written all the data to be transmitted (flag TCIF is
set in the DMA_ISR register), the BSY flag can be monitored to ensure that the SPI
communication is complete. This is required to avoid corrupting the last transmission before
disabling the SPI or entering the Stop mode. The software must first wait until TXE=1 and
then until BSY=0.
Note:
During discontinuous communications, there is a 2 APB clock period delay between the
write operation to SPI_DR and the BSY bit setting. As a consequence, it is mandatory to
wait first until TXE=1 and then until BSY=0 after writing the last data.
DocID13902 Rev 15
Serial peripheral interface (SPI)
Figure 246
and
710/1128
742

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the STM32F101 series and is the answer not in the manual?

Questions and answers

This manual is also suitable for:

Stm32f107 seriesStm32f102 seriesStm32f103 seriesStm32f105 seriesStm32f101 series

Table of Contents